918a Polyurethane Windshield Adhesive PU sealant for windscreen mirror adhesive

918a polyurethane sealant PU sealant for windshield solvent type For windshield or windscreen

HT918A is a single component, black, low viscosity, high strength, low odor polyurethane adhesive. Cured adhesive is elastomers, anti cold and hot change, good resistance to stress change performance.

Typical use

Assembly adhesive used for engineering machinery, automobile, shipbuilding and other cab windshield, and the bonding part of the metal structure of the seal.

Characteristic before curing

Representative value range

A component

Color Black

Density g/cm3(25℃) 1.85 1.15～1.25

(GB/T13354-1992)

Touch Curing(min) 40 20～60

(23℃/50%RH)

(GB/T13477.5-20)

Characteristic after curing

Tensile strength (MPa 6 ≥ 5

(GB/T528-1998)

Elongation at break (%) 500 ≥ 450

(GB/T528-1998)

Tear strength KN/m 25 ≥ 20

(GB/T 529)

The shear strength of /MPa 4 ≥ 3

(GB/T 7124)

Harness: Shore-D(GB/T 531-1999) 50-65

Work Temperature℃ -40～90

Instructions for use

Surface cleaning:

clean surface: remove the rust, dirt, water and oil etc..

Sizing:

cut a small hole in the beak suitable rubber barrel, glue mouth diameter should be considered sizing width and decide, into the glue gun start sizing operation.

Bottom:

to be with the back glass processing agent uses the specified. Glass processing agent to wait for the volatile drying time routine for 10-30 minutes, depending on the specific time when the environment temperature and decide, after the primer coating evaporation drying after the start of sizing.

Curing:

a large temperature and humidity environment on polyurethane adhesive surface drying and curing effect, low temperature, curing slow; temperature and humidity is too high, dry too fast. The best operating environmental conditions: temperature 20 to 30 DEG C for 50 ~ 70%RH, humidity exceeds 5 to 35 DEG C; the temperature, humidity 35 ~ 75%RH range please careful construction.

Polyurethane adhesive in sizing and curing process, avoid contact with chemicals containing hydroxyl, amino and, this kind of material will cause the polyurethane glue curing incomplete.

Storage:

unused plastic blocks should be tightened immediately, to seal the tube mouth save. Again, if sealed, a little crust, remove immediately after, does not affect the normal use. In the process of storage, the nozzle may also appear a few crusts, remove after normal use, does not affect the product performance.

The matters needing attention

Keep away from children.

If you accidentally come in contact with the skin, wipe in the curing a cloth before class, and using alcohol solvent scrubbing.

If the case of contact with eyes, rinse immediately with water, and medical treatment.

Recommended for use in a well ventilated place

Product safety data please refer to the product MSDS.

Package

310ml/Catridge,24 catridges/Carton

Storage

Store in cool and dry place 5-25 C

Storage period: hard pack for 9 months.